DSP TP104-plus Spezifikationen PDF herunterladen (Seite 75)

4-22

Front Panel

all possible input signals. In most cases, the following procedure should

setup the SR830 to measure the input signal.

1.Press [AUTO GAIN] to set the sensitivity.

2.Press [AUTO RESERVE].

3.Adjust the time constant and roll-off until there is no Time Constant

overload.

4.Press [AUTO PHASE] if desired.

5.Repeat if necessary.

At very low frequencies, the auto functions may not function properly.

This is because very low frequency signals overload very infrequently

and the time constants used tend to be very long.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 173 174

Keine Kommentare

DSP TP104-plus Spezifikationen Seite 75